Polar Electro GC889, Инструкция по эксплуатации

Страница: 4 / 12

4
UK
Installation
Note: If the appliance has been stored or
moved in a non-vertical position, stand it
in an upright position for approximately 12
hours before operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging and
remove the protective film from all surfaces.
2. When positioning, maintain a distance of 10cm
between the appliance and walls or other
objects for ventilation. NEVER LOCATE NEXT
TO OR NEAR A HEAT SOURCE .
3. To avoid being pushed tight against the wall
accidentally and ensure good ventilation, 2
spaces are supplied for mounting on the rear.
4. If necessary, adjust the screw feet of the
appliance to make it level.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water.
Shelf load (Max.): 10kg
Operation
Control panel
Power switch Glass heater switch
Refrigerant LED:
During refrigerating, LED is on; When
the set temperature is reached and
constant, LED is off.
Defrost LED:
During defrosting, LED is on; When
defrosting finishes, LED is off.
Up Button
Down Button
Manual defrost button / light button
SET
Set button
Adjusting the Temperature
1. Press SET button. The set temperature is
displayed.
2. Press up button or down button to
change set temperature.
3. Press SET button to exit.
Internal light
Press the button on the controller to turn the
internal light on/off.
Glass heater function
Set the switch to desired setting when necessary.
Manual Defrost
To start/stop manual defrost, press and hold
defrost button
for 6 seconds.
Controller reset
1. When the display shows “Disorder’, press
for 2 seconds until the appliance beeps.
2. Quickly press for 6 seconds until the
appliance beeps again.
3. The display will flash for 3 seconds then restore
factory settings.
GC889_UK_A5_v1_20201109.indb 4 GC889_UK_A5_v1_20201109.indb 4 2020/11/9 10:24 2020/11/9 10:24