POLAK SLIMp17, Инструкция по эксплуатации

Страница: 3 / 5

3
Use:
These lighting fixtures are intended for manufacturing plants, assembly workshops, laboratories,
test rooms, repair shops, training workshops and similar plants. These instructions are also
indicated in the online virtual consultancy of POLAK SMART FURNITURE, which can be accessed by
means of the QR code located on the product or at the web address
www.smfu.eu
Always observe valid laws, regulations, directives and standards in the country where this electrical
equipment is used. The lighting fixtures are designed for use in interiors with a dry environment, stable
temperature and adequate humidity. Protect the equipment against the effects of water or other liquids. Do
not use them in a humid environment. The lighting fixture is not intended for heavy-duty operation. Do not
expose it to heat sources; otherwise, it may heat up excessively. Components can only be maintained,
repaired and replaced by a professional company or person conforming to legal regulations for independent
work on electrical equipment.
Installation:
The SLIMp17 lighting fixture and SLIMp58 lamp is fastened to workshop furniture in the way indicated in the
images below.
fastening with a strip and magnet fastening on arm - overhung
fastening on worktop fastening on worktop side fastening on perforated panel
The lighting fixture is installed by placing it on a suspension strip, worktop or perforated panel, and connecting it to
the mains. Before connecting and disconnecting the plug, always check whether the appliance is switched off.
Disconnect it from the socket by pulling the plug, not the supply cable. Use the lighting cable fully unreeled. Locate
it in such a way as to prevent it kinking, being damaged or pulled off by a passing person. We recommend
connecting the equipment to a circuit with additional protection by means of a residual current circuit breaker.
For instructions for installation on workshop furniture, repairs and replacement of parts, see www.smfu.eu