FCC ID:
M5ZANA
Installation and Operation Instructions for the Point Sensor Analog transmitter.
Point Six, Inc.
Wireless Analog Sensor Model Point Sensor Analog
Installation and Operation Instructions
The
Point Sensor Analog
wireless analog level sensor transmits a digital value
representing either 0-20 MilliAmp, 0-5Volt or 0-10Volt levels and a unique serial
number to a 418 MHz receiver. The
Point Sensor Analog
is enclosed in a high impact
ABS enclosure for direct surface mounting in the environment to be measured.
Point
Sensor Analog
is battery operated
Application:
Apply the sensor to a surface to with double-sided adhesive tape. Make
sure that the side labeled with FCC ID is visible and away from any metal surfaces.
Service Function:
The wireless analog sensor has an installation mode switch. A
momentary push of this switch will start the convert/transmit cycles. When new and until
this button is pushed the
Point Sensor Analog
will not transmit. The
Point Sensor
Analog
will transmit a special installation status mark in the data packet immediately
after the installation/start switch is pushed. After the start a push of the installation
switch will result in the immediate transmission of data and ID and installation status
mark.
Battery:
A 3.6 Volt lithium battery powers the
Point Sensor Analog
wireless sensor.
The battery will last for more than 10 years in the idle state (as shipped from the
manufacturer). The
Point Sensor Analog
will transmit data for as long as 10 years at a
rate of once each minute once started. The
Point Sensor Analog
is completely covered
with a water resistant conformal coating to protect the electronics from the environment
and condensation. The user may replace the battery. The
Point Sensor Analog
may be
placed in a quiescent state (battery life greater than 10 years) by holding the installation
switch closed for more than 4 seconds.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES, OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT
ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY
CAUSE UNDESERED OPERATION
FCC ID: M5ZANA
MADE IN USA
