Hang And Secure Screen On
TV Mounting Plate
5
3
Attach tilting arms to screen.
A-I x4
Spacers ‘
G
’ to ‘
I
’ can be used between the TV
and bracket where the TV rear panel is not flat
or where extra depth is required for cable access.
They can also be used on the screw head side
to adapt screws to shorter lengths.
Stepped spacers fit into the holes on each
mounting arm on either the TV or bracket side.
A
Lift TV in to position, bring the bottom of the TV away from the wall and tilt the
top edge in to allow the arms to hook over the wall plate.
B
Insert fixing screws
J
Additional Padlocks can also be added to either or both arms.
Landscape
Portrait
F- I x4
A-Dx4
Ex4
B
A
Jx2
Jx2
6
Tilt adjustment
6A -
The screen should be supported in its
upright position by an additional person.
6B -
Loosen the tilt adjustment allen bolts
on both mounting arms.
6C -
Remove retaining pozi drive screw
from both mounting arms.
6D -
Lower the tilt angle of the screen to
desired level and tighten one adjustment
allen bolt followed by the other making sure
the angle of both mounting arms is the same.
Note:
When screens are extra large or the
VESA mounting pattern is small relative to the
screen the use of extra long tools would aid
installation.
Tilt adjustment
allen bolt
Pozi drive
retaining screw
Two persons should be present to adjust the tilt angle
of the screen and bracket.
