DU-0
= dummy zero: 0= without dummy zero
1= with dummy zero
2= dual accuracy (0.5/1) or (5/10)
CS
= Capacity Selection: 1 = Only One Capacity
2= Two Capacity
3= Three Capacity
CAP-1
= first capacity ( first scale range for triple capacity) (Enter)
(If not use inter 00000 value)
DP1
= decimal point (DP) of cap1
FD1
= accuracy class (FIRST DIGIT) of cap1
CAP-2
= second scale capacity (enter)
(If not use inter 00000 value)
DP2
= decimal point (DP) of cap2
FD2
= accuracy class (FIRST DIGIT) of cap2
CAP-3
= scale capacity (enter)
DP3
= decimal point (DP) of cap3
FD3
= accuracy class (FIRST DIGIT) of cap3
Litd =
Feed
liter density
How to see LoadCell counts:
Step 1: Hold
MODE key
power on = see machine internal count
Step 2: On No-load machine count must be 3000 to 12000 count
Step 3: Usable machine counts are up to 300000
How to Calibrate the Device:
Step 1: Make sure that the Machine is in weighing mode
Step 2: Keep Weight on the Pan/ platform (near 30% of maximum capacity.)
Step 3:
Press MR Key
and hold then press
MODE key
Step 4:
Display Show
PASSWAD
(Enter)
Step 5: If display shows
READML
(Then check your weight)
Step 5: Display show
00000 (
feed above weight by
M+& MR
Keys)
Step 6: Press ENTER
KEY
to complete calibration.
How to set up Piece counting mode:
Step 1: Make sure that machine is in weighing mode.
Step 2: Keep some pieces on the pan/ platform.
Step 3: Display shows you the weight.
Step 4:
Press MR Key & M+ Key
display show
COUNT
Step 5: Then press
TARE/ENTER key
Step 6: Display show
P. 00000
Step 7: Enter the number of pieces which kept on the pan (press Enter key)
Step 8: Now machine working in counting mode.
Step 9: For weight mode, press again
MODE key
.
