6. Installation:
1.
Connect all D2-D9 pins to the appropriate MPEG decoder output pins of your DVD player or set-top
box. The D0 and D1 pins are not used because the digital video output of the MPEG decoders in
the DVD players and set-top boxes is 8-bit data only.
2.
Connect the 5 volt and ground to the appropriate location on the circuit board of the DVD player or
set-top box.
7. Finish:
1.
After the modification, power up the DVD player or set-top box and the LED (D2) on the kit should
light up indicating that it is receiving a 27MHz clock signal from the MPEG decoder of the DVD
player or set-top box.
2.
Connect BNC cables from the SDI output of this Mod. Kit to your SDI capture device.
Example: An SDI Mod. Kit installed on a Panasonic RP82 DVD player is shown in the following picture.
Example: the pin assignment of RP82's MPEG2 decoder
