PMI SB5100 Скачать руководство пользователя страница 4

Страница: 4 / 11

If a USB device or SD card is present, the radio will default to the
USB/SD mode, if no USB device or SD card is present, the radio will
default to line in mode.

To increase volume, press and hold on the unit or on the
remote.

To decrease volume press and hold on the unit or on the
remote.

To mute the output press on the remote.

Press on the remote to cycle through the equalizer options.

Press the button on the radio or on the remote to switch
between modes.

Available modes:
- Line In
- Bluetooth
- FM Radio
- USB/SD Card

To turn off the radio module press on the remote. Press
again to turn the radio module back on.

Note:

It is recommended to

unplug the entire ShopBlaster evaporative cooler unit if neither the
radio nor the cooler are being used.

USB/SD Card Mode:

This unit will support up to a 32 GB SD card and a 16 GB USB flash
drive.

The unit will automatically switch to this mode when an SD card or
USB flash drive is connected.

Press and on the module or and to select the desired
track.

Tracks can also be selected using the number pad on the remote.

Press on the module or on the remote to pause playback
and press it again to resume playback.

Press to repeat the current song.

Press on the remote to stop playback.

01-999-2534

Page 4

Controls

Rocker-type control switches are used to select the operating mode
of the cooler. These switches control fan speed (FAN-HIGH/OFF/
LOW) and the pump operation (COOL-ON/OFF). To eliminate a
rush of warm air when starting the cooler, be sure to turn the pump
(COOL) on for a few minutes before turning on the blower motor
(FAN) in low or high speed.

Maintenance Schedule

Regular maintenance and periodic inspection is a key to long and
successful service of your Shop Blaster Cooler. The cooler should
be serviced at least once a year, or more often if required. For
maximum efficiency, longer life and appearance, every two months
during operation, the cooler should be inspected and cleaned.
Drain water from the unit every 8-10 hours of operation to minimize
scaling build up.

Note: Do Not Undercoat the Water Reservoir

Your cooler's water reservoir is finished with our Peblar XT®
appliance-type finish. It is so hard that asphalt-type cooler
undercoating will not stick to it. Undercoating will break free,
clogging the pump and water distributor.

NOTE:

Do not use cooler cleaners, cooler treatments or

other chemical additives in this evaporative cooler. Use of
any additives or water treatment will void your warranty and
impair the life of the cooler.

Before starting any maintenance operation, read thoroughly
all operating and maintenance instructions and observe all
cautions and warnings.

CAUTION: Disconnect all electrical power to the cooler by
removing plug from receptacle before attempting to install,
open, or service your cooler.

Even while routinely inspecting or servicing the inside, the
cooler can be accidentally started. Keep all personnel away
from the cooler and electrical supply when you are working
on it. Before servicing or cleaning unit, switch “COOL” and
“FAN” to the OFF position and remove power cord from
receptacle.

Convenience Outlet

A convenience outlet is located on the front of the unit. This outlet
is protected by a 3 Amp circuit breaker located directly above the
outlet. Do not attempt to plug in a device or combination of devices
that will draw more than 3 amps total. If the circuit breaker is
tripped, wait for the circuit breaker to reengage and then push the
switch to reset.

Stereo Operation

When the Shop Blaster unit is plugged in the radio screen will
display HI

CONTROL SWITCHES

MODE

STOP

MODE

STOP

MODE

STOP

MODE

STOP

MODE