TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 18
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
The
USB Connection
allows communication between the miniPAR Logger and an external HOST
computer. When connected, the miniPAR Logger is in HALT mode regardless of the Logger Control
Switch position. When disconnected, the miniPAR
Logger’s mode is controlled by the Logger Control
Switch position. The switch position may be changed while the USB is connected.
The
Main Batteries
(2 X AA on side opposite to pictured side above) provide main power to the
miniPAR Logger. Note the positive (+) terminal. Batteries are described in Chapter 1 of this manual.
3.4 Battery Replacement
Be sure that the replacement batteries are compatible with the miniPAR Logger. PME recommends
Energizer L91 AA size lithium batteries or Duracell AA size alkaline batteries.
http://data.energizer.com/PDFs/l91.pdf
http://ww2.duracell.com/media/en-
US/pdf/gtcl/Product_Data_Sheet/NA_DATASHEETS/MN1500_US_CT.pdf
Caution: Improper replacement of the batteries will damage the miniPAR Logger.
Follow these steps:
1. Move the miniPAR
Logger’s Control Switch to the “Halt” position.
2. Remove the depleted batteries
noting the position of the (+) terminal
.
3. Switch minPAR to RECORD, then back to HALT. Wait 1 minute.
4. Use only new, fully charged batteries, both of the same type.
5. Install fresh batteries with the
(+) position the same as the removed batteries
. The (+)
position is also marked on the inside of the battery holder.
6. The miniPAR
Logger’s LED Light should flash to indicate that the software is beginning
operation within a second or two after you complete the battery installation. At this time the
logger will enter the mode selected by the Logger Control Switch (which should initially be
“Halt” from Step 1).
Please be aware that the warranty will become void if the batteries are installed backwards.
Enjoy your new miniPAR!
