8
TABLE 1
Switch 2
1
2
3
4
5
6
7
8
PMC - 60 MTR
on
on
off
off
off
off
X
X
PMC - 90 MTR
on
on
off
off
off
off
X
X
PMC - 130 MTR
off
off
off
off
off
off
X
X
PMC - 160 MTR
on
off
off
off
off
off
X
X
PMC - 260 MTR
on
off
off
off
off
off
X
X
PMC - 320 MTR
on
off
off
off
off
off
X
X
PMC - 420 MTR
on
off
off
off
off
off
X
X
PMC - 600 MTR
on
on
on
off
off
off
X
X
Test Mode
X
X
X
X
X
X
on
X
Standby
X
X
X
X
X
X
X
off
The first 6 switches of dip switch 2 are the current settings and are approximately 40 ma per bit for 2.5 amp
drivers and 56ma per bits for a 3.5amp driver. The off position of the switch selects the current; switch 6 is
the most significant bit. The PMC supplied motors run at approximately 2.5 amp/phase peak current. The
motor current table above is for 2.5 amp version. In the 2.5amp version the user can activate the standby
mode by selecting switch 2-8 to off position. Standby mode is automatically entered in the 3.5 amp model
regardless of the switch setting
Test
This is a mode that is entered upon power up if switch 2-7 is in the on position. The motor will rotate
at 0.7 rev/sec after power up. Power must be turned off and switch 2-7 put in the off position to leave test
mode.
The commands are ignored in test mode. Set Test mode to the off position before entering command mode
.
Auto-Standby
The motor current is reduced to 50% after 2 seconds of no movement in the 2.5 amp version when
switch 2-8 is selected OFF position. The motor current goes to standby mode regardless of the switch
setting in the 3.5 amp version.
Switch 1
1
2
3
4
5
6
7
8
wave shape
0%
X
X
X
on
on
on
X
X
+3%
X
X
X
off
on
on
X
X
-3%
X
X
X
on
off
on
X
X
5%
X
X
X
off
off
on
X
X
-5%
X
X
X
on
on
off
X
X
enable DN
on
X
X
X
X
X
X
X
