0000104046/010822/A MDB-Compact PRO
7
1.8
Ambient and process conditions
Process temperature:
-
min.
-
nom.
-
max.
5°C (41°F)
20°C (68°F)
70°C (158°F)
Max. relative humidity
80%
Suitable for outdoor use
no
1.9
Transport of the unit
You cannot hold the manufacturer liable for any transportation
damage after delivery of the unit. Handle the unit and the
accompanying options and/or accessories, if any, with care.
Refer to paragraph 4.3 for lifting instructions.
2
PRODUCT DESCRIPTION
2.1
Components
The MDB-Compact consists of the following main components
and elements:
A
Corner plate with eye bolt (4)
B
Cover plate
C
RamAir™ pulse amplifier (filter cleaning system), incl.
compressed air tank
D
Air inlet module
E Dust drawer
F Filter cartridge (2/4/6)
G Extraction fan
H Air outlet
I
ControlPro/Panel
J
ControlPro/HMI
Fig. 2.1
C
D
B
E
H
I
J
G
F
A (4x)
Main components and elements
2.2
Operation
The polluted air from the external device is
extracted through the air inlet module on the left
2
side of the unit. The air then passes the filter
cartridges inside the housing. The filtered air is blown back
into the workshop by the outlet of the fan housing.
The filter cartridges are cleaned individually by compressed air
pulses. This system is called the RamAir™ pulse amplifier. The
dust and dirt particles are collected in the dust drawer.
Deflector plates behind the air inlet module balance the dust
load on the filter cartridges. They operate as spark arresters at
the same time.
2.2.1 Control equipment
The MDB-Compact is connected to ControlPro control
equipment.
ControlPro is an intelligent platform that controls the filter
system as well as the connected extraction fan. It contains an
extensive feature package to monitor and arrange the
RamAir™ pulse amplifier (filter cleaning system), the required
airflow and the corresponding fan speed. By means of the
user-friendly HMI you can program all desired parameters. The
HMI gives a clear insight into the system status and
performance at all times.
ControlPro allows for remote access via a network connection.
3
SAFETY INSTRUCTIONS
General
The manufacturer does not accept any liability for
damage to the product or personal injury caused by
ignoring of the safety instructions in this manual, or
by negligence during installation, use, maintenance, and repair
of the product mentioned on the cover of this document and
any corresponding accessories.
Specific working conditions or used accessories may require
additional safety instructions. Immediately contact your
supplier if you detect a potential danger when using the
product.
The user of the product is always fully responsible for
observing the local safety instructions and regulations.
Obey all applicable safety instructions and regulations.
User manual
-
Everyone working on or with the product, must be familiar
with the contents of this manual and must strictly observe
the instructions therein. The management should instruct the
personnel in accordance with the manual and observe all
instructions and directions given.
-
Do not change the order of the steps to perform.
-
Always keep the manual with the product.
Pictograms and instructions on the product (if
present)
-
The pictograms, warning and instructions attached to the
product are part of the safety features. They must not be
covered or removed and must be present and legible during
the entire life of the product.
-
Immediately replace or repair damaged or illegible
pictograms, warnings and instructions.
2.
In case of an MDB-4/C and MDB-6/C, it is possible to install the air inlet
module on top of the unit
