Electric TV Lift, VL-PLA-ST2-ST3
5
. Installation.
(Proceed only after having read the previous pages)
1) Check box contents with page 6 and read the remote RF instruction. Connect the lift
(#1) to the RF Module (#5).
Only once all other connections have been made
plug power supply (#7) into the wall socket
. Position lift vertically. Test the lift us-
ing the rocker switch (#9) 10cm/4” up and down is enough. Releasing the rocker will
stop the lift. Now test the RF Remote, the default setting on the RF handset is one
press for continuous movement, press again to stop.
2) Mount the lift unit (#1) on the back panel of the cabinet or mounting surface in a loca-
tion that will allow full up and down movement of the TV. When operating a hinged lid
the lift must operate for a minimum of 4mm/1/8” before any contact happens.
3)
Fasten the lift securely using the 8 screw holes shown below. Screws
must be appropriate for the material being used.
The lift must be mounted vertically
(using a spirit level). The surface to which the lift is mounted must be totally flat, caus-
ing no stress / twist across the lift carcase. Mounting screws should only be lightly
tightened to avoid uneven stress on the lift carcase.
4)
Mount the power bracket (#8)
to the right side adjacent to the lift
as shown in the drawing page 9. Secure with 2 screws.
5) Fasten R.F. Module (#5) next to the power supply leaving enough room to connect
the wires.
6) Mount rocker switch (#9) the hole size required is 30mm. Secure excess wire to keep
away from moving parts.
8
