Plura RUB VM, Функциональное описание и технические характеристики

Страница: 21 / 32

Functional Description and Specifications RUB VM
Page 21
System Set-up reflects the current set-up as selected by a configuration tool:
set-up ‘ OK’ or ‘ failure’ . This is the result of the power-on check. In case of a failure all
settings have been reset to the default values automatically.
GPI alarm output ‘ low active ’ or ‘ high active ’.
maximum number of simultaneous changeover switching 1 … 6.
For each channel: channel 1 to 6 + spare:
changeover relay ‘ auto ’ or ‘ open ’ or ‘ close ’. Indicates the operating mode of each relay.
GPI alarm output ‘ enabled ’ or ‘ disabled ’.
SNMP traps ‘ enabled ’ or ‘ disabled ’.
System Status shows all relevant status information:
input signal status ‘ OK’ / ‘ failure’ . This status corresponds to status of the spare output.
frequency ’10 MHz ’. Indicates the fixed nominal fre quency of the signal input.
input signal received ’yes ’ or ‘ no ’. Monitoring and changeover procedure start if at least
once a valid signal has been detected.
led OPER ‘ on ’/‘ off ’. ‘on’ if the module is operating.
led SIGNAL ‘ on ’/‘ off ’. ‘on’ if a valid in put signal has been detected once.
led SET ‘ on ’/‘ off ’. ‘on’ during connection with “RUBIDIUM CONFIGURATION“.
led ERROR ‘ on ’/‘ off ’. ‘on’ if any error has been detected ( total number of errors > 0).
lamp 1 ‘ on ’/‘ off ’. ‘on’ if any alarm has been set ( total number of alarms > 0).
lamp 2 ‘ on ’/‘ off ’. No function.
lamp 3 ‘ on ’/‘ off ’. ‘on’ if input signal is present (IN) – corresponds to the spare output.
lamp 4 ‘ on ’/‘ off ’. ‘on’ if all the six output signals are present (OUT).
total number of errors 0 – 65 535. Current value of the overall error counter.
total number of alarms 0 – 65 535. Current value of the overall alarm counter.
number of activated changeover relays 0 – 6.
For each channel: Channel 1 to 6 + spare:
status ‘ok’ or ‘fail’. Indicates the curr ent signal status.
changeover relay ‘ open ’ or ‘ closed ’. Current state of the relay (channel 1 - 6).
GPI alarm output ‘ - ’ or ‘ set ’. Indicates the current state of the GPI al arm.
errors 0 – 65 535. Current value of the individual error counter.
alarms 0 – 65 535. Current value of the individual alarm counter.
changeover events: Reports about the last changeover. Reset of these data by key FAIL or
RESET or button ERROR RESET of a configuration tool.
automatic 0 – 65 535. Counts the automatic changeover events since last RESET.
manual 0 – 65 535. Counts the manual changeover events since last RESET.
last event Indicates the kind of the last event: automatic/manual – open/close.
time since last event 00000:00:00 [HHHHH:MM:SS]. Time elapsed since last changeover.