Plockmatic F142-001, Руководство по эксплуатации

Страница: 25 / 40

_________________________________________________________________________
25
2
Feeder Settings
Element Description
A AUTO settings Toggles automatic feeder mode. In AUTO mode feeder settings are
calculated automatically depending on paper size and weight. In
most cases AUTO settings will provide optimum feeding
performance. Switching AUTO settings off allows the operator to
make adjustments to fans.
B DSD settings Allows the operator to switch ultrasonic double sheet detection
(DSD) off. For some media types such as thick card or laminated
media the ultrasonic sensor may give incorrect readings. In this case
switch the sensor off.
C Registration fan Adjusts the force with which the sheet is registered against the paper
wall. Increase this if the sheets exit the feeder in an inconsistent
orientation. Thinner sheets can be damaged (over-registered) if this
value is set too high.
D Paper density Paper density is a value measured by the separated paper (SP)
sensor. A higher value means more sheets are floated and the
unfloated pile is closer to the vacuum belts.
E Separation fan The front separation fan (air knife) floats the top sheets in the pile.
Insufficient separation air can result in frequent misfeeds, while
excessive airflow can float too many sheets and result in double
feeds.
F Side float fan The side fan can be used to add additional air for media that is
difficult to separate with the front fan only. Excessive side float air
can cause issues with registration.
G Vacuum fan Vacuum fan controls the force with which the top sheet in the pile is
pulled in contact with the feed belts. Insufficient vacuum can result
in frequent misfeeds, while excessive vacuum can pick up several
sheets and result in double feeds.
H Test settings This button allows the operator to start all feeder fans to check if
the sheets are separating properly.
B
E
F G H
A
C
D