Plinius SA-100 Series, Инструкция по эксплуатации

Страница: 14 / 23

14
RCA BRIDGED MONO
This option configures your amplifier to drive one loudspeaker from one unbalanced signal fed to the red
RIGHT RCA input. In bridged mono mode the only input made to your preamplifier is to the red RIGHT
channel RCA input. The black LEFT channel RCA input is not connected.
Next your loudspeakers are connected to both positive (+) channel output terminals. So the positive red
connection on your loudspeaker is connected to the red RIGHT amplifier output, and the negative black
connection on the loudspeaker should be connected to the red LEFT amplifier output. DO NOT CONNECT
ANYTHING AT ALL TO THE NEGATIVE (-) TERMINALS. MAKING A CONNECTION TO THE NEGATIVE (-)
TERMINALS OF THE AMPLIFIER IN THIS MODE CAN CAUSE SERIOUS DAMAGE!
You can still connect two loudspeakers using the lower positive (+) amplifier output terminals. This is
explained in the bi-wiring section following.
Now turn the ACS switch fully clockwise then one position counter-clockwise so that it is in the RCA
Bridged Mono position. It is now safe to switch on your amplifier.
XLR inputs are becoming more popular and provide professional quality signal wiring. XLR inputs allow
the use of fully balanced or quasi balanced signals from preamplifiers, CD players and other ancillary
equipment to be fed directly to the amplifier. The technical advantages of this system of wiring may be
fully realised here due to the dedicated ‘balanced’ input circuit facilities provided.
XLR STEREO
Connect your preamplifier or input signal to the two XLR inputs at the top of the amplifier back panel.
Make sure you connect the RIGHT XLR input and LEFT XLR inputs to the right and left outputs from your
preamplifier respectively. Also make sure the XLR connectors click into place.
Next connect your loudspeaker wires to the output posts on either side of the rear panel. Connect your
right loudspeaker (ie the one on the right of you when seated in your normal listening position) to the right
output terminals, ensuring that the red positive (+) terminal is connected to the red terminal on your
loudspeaker. Do the same with the black or negative (-) terminals.
Now turn the ACS switch fully clockwise then two positions counter-clockwise so that it is in the XLR
Stereo position. It is now safe to switch on your amplifier.
XLR BALANCED MONO
As with RCA Bridged Mono, this option configures your amplifier to drive one loudspeaker, but from one
balanced line input connected to the RIGHT XLR Input. In balanced mono mode the only input made to
your preamplifier is to the RIGHT channel XLR input. The LEFT channel XLR input is not connected.