4 / 9
MENU SETTINGS
The following settings are adjustable from the belt pack menu.
To access the menu, press and hold the
MODE
button for 3 seconds, until the “GRP” symbol is
blinking on the LCD. Then, short-press the
MODE
button the specified number of times to access
the setting you wish to change. Once you have finished your changes, press and hold
MODE
to save
your selection and exit the menu.
•
Side Tone On/Off
- Side tone allows you to hear yourself while talking. Louder environments
may require you to increase your side tone.
» To adjust side tone, access the belt pack menu, then press the MODE button twice. When the
“S_” value is blinking on the LCD, use the /
−
buttons to select an option from S0–S5.
» “S0” is off. “S1” is the lowest side tone level. “S5” is the highest.
» The default side tone setting is “S3.”
•
Receiving Mode Selection
- This setting allows you to set the belt pack to full duplex mode
(both receiving and transmitting) or set it to receive only (i.e., listen only, which disables the belt
pack’s talk function).
» To switch the receiving mode setting, access the belt pack menu, then press the MODE
button three (3) times. When the “P_” value is blinking on the LCD, use the /
−
buttons to select between “PO” and “PF.”
» “PO” is full duplex (both receiving and transmitting). This mode may only be used with pack
IDs 00–04.
» “PF” is receive only (i.e., listen only). This mode may be used with any pack ID, but if you wish
to set up multiple listen-only users, you may do so by repeating ID “05” as needed, and setting
each pack to “PF” mode. This is an exception to the rule that all belt packs must have a unique
ID number.
» The default mode setting is “PO.”
•
Microphone Sensitivity Level Control
- Set microphone sensitivity based on your environment
and headset capabilities. Louder environments may require you to reduce the mic sensitivity,
while quieter environments may require you to increase it.
» To adjust the mic sensitivity setting, access the belt pack menu, then press the MODE button
four (4) times. When the “C_” value is blinking on the LCD, use the /
−
buttons to
select an option from C 1–C5.
» “C 1” is the lowest sensitivity level. “C5” is the highest.
» The default microphone sensitivity level setting is “C 1.”
•
Audio Output High/Low
- Higher audio output is recommended for louder environments.
Changing the output setting here results in a gain increase or decrease of 3 dB.
» To switch the audio output setting, access the belt pack menu, then press the MODE button
five (5) times. When the “U_” value is blinking on the LCD, use the
/
−
buttons to
select between “UL” and “UH.”
» “UL” is audio output low. “UH” is audio output high.
» The default audio output setting is “UL” (audio output low).
