2-Wire Intercom Connectivity
Note
: If you are
not
connecting a hardwire system, be sure the
2-Wire Type
is set to
OFF
or the system could experience termination-related issues and poor audio. See the
procedure below for more information on how to change this setting.
Always confirm that the non-Pliant 2-Wire intercom system and the CB2 wireless system are functioning
properly separately before connecting them together. Use the procedures below to configure the 2-Wire
connection from the BaseStation's Wired Settings menu.
Under the
Wired Settings
menu, select
Intercom Settings
:
1. Use the Navigational controls to navigate to the desired setting for a 2-Wire port.
A. For intercom “Type,” press
Enter
to view the available list of compatible types:
RTS Ch 1
,
RTS Ch 2
,
AudioCom (Balanced)
, or
Clear-Com
. You can also select
Off
. Use the
navigation buttons to scroll through the list, and press
Enter
when the desired setting is
highlighted.
B. Determine if you would like to send and receive Call signals from the CB2 wireless system
to the connected 2-Wire intercom system. Press
Enter
to view and select
ON
or
OFF
. See
the Call section of
"Intercom Settings Menu" on page 52
for more information.
C. The Echo Cancellation (ECAN) setting for the 2-Wire ports is on by default. Pliant highly
recommends that ECAN remain on even if a 2-Wire system is not in use. If you wish to
change this setting, press
Enter
to view and select
ON
or
OFF
. See the Echo Cancellation
section of
"Intercom Settings Menu" on page 52
for more information.
2. Now that your settings are established, connect the 2-Wire intercom system to the appropriate
ports via 3-pin XLR cables/connectors.
3. After connecting the 2-Wire intercom system, initiate Auto Null for the appropriate ports or all ports
of this particular BaseStation. See
for more information.
Operation - 56
Содержание CREWCOM CB2
Страница 1: ...CB2 System OPERATING MANUAL ...
Страница 2: ... ii ...
Страница 41: ...Figure 12 RP Rear and Battery Compartment Door Setup and Installation 34 ...
