Plein Air R-1200, Инструкция по эксплуатации

Страница: 12 / 17

R-1200
DT Istr (R-1200) 05/11
–
REV_6_05/2018 12/17
nylon bags, etc.) out of the reach of children. Before turning the appliance on, check that the voltage and
frequency of the power socket are compatible with those indicated in the product technical plate.
2. This appliance must be connected to an approved mains socket that complies with the safety regulations on
electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage
and must be equipped with an earth cable.
3. The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use
other than its intended purpose shall be deemed to be improper and hazardous.
4. The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5. The appliance has dangerous components that must be kept out of the reach of children.
6. Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
7. The power cord must never be in contact with the hot surfaces of the appliance.
8. Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
9. If the appliance does not work properly, immediately turn it off and disconnect it from the mains socket.
For repairs, contact a technical support center authorized by the manufacturer, and require that original
spare parts be used. Using parts that do not conform to the product may seriously compromise its correct
operation.
10. This heater is hot when in use, in order to avoid burns do not touch the surface. Keep away from
combustible surfaces, curtains and furniture, etc. Keep the heater at least one meter away from any surface.
11.
To disconnect heater, turn controls to “OFF”
, then remove the plug from outlet.
INSTRUCTIONS FOR USE
A
: Pull switch cord
B
: Power indicator
C
: Body
D
: Wall mounting bracket
E
: Cover mounting bracket
LOCATION OF THE APPLIANCE
Wall mounting
The appliance must be fixed to the wall and must be placed
at a minimum height of 1.8 meters from the ground.
Before drilling the wall, in order to install the appliance, be
sure it complies with all the following minimum safety
distances, from walls and ceilings as shown in figure.
Attention: the plug must be in accessible location.
1. Remove the bracket
"
D
"
from the appliance and
remove the cover of the bracket itself
"
E
"
.
2. Realize 4 holes on the wall (same diameter of the
dowels) at the same distance of the holes of bracket.
3. Insert the dowels into holes and fix the bracket to the
wall with 4 screws.
4. Reassemble the cover
"
E
"
on the bracket.
5. Fix the appliance to the bracket
"
D
"
and adjust the
grade.