CMTS-2000
DT Istr (CMTS-2000)_05/17_Rev.0
10/20
7.
In order to have a good air aspiration and to avoid damaging of the product, maintain the air inlet and outlet
free from objects.
8.
The appliance has dangerous components that must be kept out of the reach of children.
9.
Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
10.
The power cord must never be in contact with the hot surfaces of the appliance.
11.
Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
12.
If the appliance does not work properly, immediately turn it off and disconnect it from the mains socket.
For repairs, contact a technical support center authorized by the manufacturer, and require that original
spare parts be used. Using parts that do not conform to the product may seriously compromise its correct
operation.
13.
In order to unplug the appliance, select
"ON/OFF"
and disconnect the plug from the power socket.
BASE INSTALLATION
INSTRUCTIONS FOR USE
The fan heater features a top panel with button to select the different functions:
During operation the fan heater must be at a minimum distance of 50 cm from walls or other objects. Direct the
air flow towards such a point so that room heating is optimised. Do not direct the heat flow towards corners or
reduced spaces, or towards the floor or ceiling.
1.
The fan heater is equipped with two levels of heating power: to have the minimum power, press only the
first button
"1000W"
and, to have the maximum power, press both the buttons
"1000W".
2.
To heat a room quickly, set the fan heater to its maximum position (activate both power buttons). Once the
room has reached an agreeable temperature, set the fan heater to a lower position in order to reduce
consumption and to prevent the room from getting too hot.
3.
Select low or maximum heat emission.
4.
The fan heater features the practical oscillation mode, which can be activated by pressing the button
"OSC".
5.
In order to unplug the appliance, press the button
"ON/OFF".
6.
Before disconnecting the plug from the mains socket, switch off the appliance.
SAFETY MEASURES
To avoid damages and dangerous situations caused by overheating, the fan heater is equipped with a safety
device that stops its operation in case of overheating, for example, due to a total or partial obstruction of the
grills. In this case, disconnect the appliance from the mains socket, wait for around 30 minutes so that it cools
down, and remove the object that is obstructing the grills. At this point, it is possible to start the appliance
again, as described above. The appliance should operate correctly. Should the problem come up again, contact
the nearest support centre.
To ensure its safe use, the appliance features a tip-over protection system. In case of accidental fall, the
appliance turns off automatically. CAUTION: If the heater is straightened, automatically restarts.
MAINTENANCE
Connect the A and B parts of the
base.
Connect the base to the bottom of
the unit.
Fix the base to the appliance using
the four screws.
ON/OFF
Power ON/Power OFF
1000W
Heating function at minimum power if pressed
only a button.
Heating function at maximum power if pressed
both the buttons
1000W
OSC
Auto swing function
