ALM1200
D
D
T
T
I
I
s
s
t
t
r
r
(
(
A
A
L
L
M
M
1
1
2
2
0
0
0
0
)
)
0
0
8
8
/
/
0
0
7
7
_
_
R
R
E
E
V
V
9
9
_
_
0
0
5
5
/
/
1
1
8
8
11/14
a safe way and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance shall not
be made by children without supervision.
12.
This appliance is exclusively designed for indoor uses.
13.
Do not place the appliance directly below a power socket.
14.
This equipment should not be operating without monitoring.
15.
CAUTION: some parts of this product can become very hot
and cause burn. Particular attention has to be given where children
and vulnerable people are present.
16.
The bulb must be replaced by qualified person.
GENERAL WARNINGS
1.
Remove all the packaging material and make sure that the appliance is in good condition. If you have any
doubt, do not use the appliance and contact our After-Sales Service. Keep the packaging material (staples,
nylon bags, etc.) out of the reach of children. Before turning the fan heater on, check that the voltage and
frequency of the power socket are compatible with those indicated in the product technical plate.
2.
This appliance must be connected to an approved mains socket that complies with the safety regulations on
electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage
and must be equipped with an earth cable.
3.
The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use
other than its intended purpose shall be deemed to be improper and hazardous.
4.
The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5.
Always place the fan heater on a flat and even surface, it should not be exposed to vibration or mechanical
stress.
6.
The appliance has dangerous components that must be kept out of the reach of children.
7.
Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
8.
The power cord must never be in contact with the hot surfaces of the fan heater.
9.
Do not lay the power cord under a carpet. Pay attention not to place the power cable where it is likely to get
into people's way.
10.
If the appliance does not work properly, immediately turn off the fan heater and disconnect it from the
mains socket. For repairs, contact a technical support center authorized by the manufacturer, and require
that original spare parts be used. Using parts that do not conform to the product may seriously compromise
its correct operation. The device must not be opened, processed or modified out by unqualified personnel.
11.
In order to unplug the appliance, select button (OFF) and disconnect the plug from the power socket.
INSTRUCTIONS FOR USE AND ASSEMBLING
Assemble the heater main structure with the base, as it is indicated in the following sequences.
1.
Remove the screws located on the bottom of the main structure.
2.
Insert the cord in the hole located on the base and then assemble the structure with the base.
3.
Tightly fasten the screws so as to join the base to the main structure. Insert the power cord through the
corresponding openings and fix it with the clamp.
4.
Make sure that the appliance is in good condition and securely positioned.
5.
After having securely positioned it, plug in the power cord.
1.
ON/OFF button - Lamp on button – 400W
2.
Lamp on button - 400W
3.
Lamp on button - 400W