7
8.
There are four door panel hinges (two in the
top track and two in the bottom track). The
door panel hinges are designed to be adjusted.
If the door panels are not evenly aligned or if
there is too much space between the center
of the door panels (when they are in a closed
position), you may adjust them as follows:
Open the door panels. Reach inside and loosen
the panel hinge screws.
Do not remove the
screws.
Slide the door panel hinges left or
right until the space between the center of the
door panels is even, as shown in Figure 8.
Return door panels to their original position.
Carefully maintain the door panel hinge
position and tighten screws.
9. To remove the door panels for cleaning or
replacement, begin by opening the door
panels. Remove the door panel hinge
screws from the top and bottom hinges
as shown in Figure 9. Remove the door
panel(s).
INSTALLATION INSTRUCTIONS
9
8
NOTE:
In some models, a riser bar is provided with two sets of holes (top and bottom).
For proper flush fit, use the top or bottom set of holes, whichever are suitable to your
frame. Remember that proper flush means the back edges of the riser bar and the back
edges of the bottom frame assembly are even. In some cases, the riser bar will extend in
front of the frame assembly, which is correct.
Door Hinge
Door Hinge
