Guidelines & Information (fs SPE_noslide)
Annex Page 1 of 7
Guidelines
Important ! Please Read Completely Before Beginning Installation.
According
to a report published by the U. S. Consumer Product Safety Commission (C.P.S.C.)
72% of all playground injuries result from accidental falls. With this in mind, this
equipment is designed to fill the need for safe yet challenging play. In conjunction
with design efforts to reduce the possibilities of injuries, this equipment
must
be installed "Step by Step" per our installation instructions. As a new owner you
are responsible for the correct installation, safe use, and maintenance of your
equipment.
Installation Guidelines
•
Identify all parts and thoroughly read the assembly instructions before
beginning construction.
•
Refer to your playground equipment plan and footing diagram to assure
the equipment purchased
will fit into your selected site area. The use and no-
encroachment zones around the play equipment shall be obstacle-free areas
designated for unrestricted circulation.
• ASTM compliance:
The overall use zone measurements for stationary play
equipment should extend a minimum of 72 inches (1829 mm) from its perimeter;
dimensions and configuration of the use zone are dependent upon the types of
included play equipment. The use zone of stationary play equipment may be
overlapped by the use zone of adjacent stationary play equipment if the adjacent
designated play surfaces are no greater than 30 inches (762 mm) above the
protective surfacing level. They should be a minimum of 72 inches (1829 mm)
apart. If the adjacent designated play surfaces are greater than 30 inches (762
mm) above the protective surfacing level, the pieces of equipment should be a
minimum of 108 inches (2743 mm) apart.
• CSA compliance:
The overall use zone measurements for stationary play
equipment should extend a minimum of 1800 mm from its perimeter; dimensions
and configuration of the use zone are dependent upon the types of included play
equipment. The use zone of stationary play equipment may be overlapped by the
use zone of adjacent stationary play equipment if the adjacent designated play
surfaces are no greater than 700 mm above the protective surfacing level. They
should be a minimum of 1800 mm apart.
• EN compliance:
The overall use zone measurements for stationary play
equipment are dependent upon the fall height of the equipment. For a fall height
exceeding 1500 mm a formula is applied to determine the use zone (impact zone)
of the equipment. There is a minimum of 1500 mm from its perimeter; dimensions
and configuration of the use zone are dependent upon the types of included play
equipment. Refer to the Use Zone diagram or master structure drawing.
•
Site layout is a critical part of the overall installation. Footings must be
measured and marked accurately according to the footing diagram. A level and
clear installation site is ideal.
•
Good drainage around the structure and its supports is important. Inquire with
local contractors for appropriate recommendations.
•
After laying out all footings and before digging holes, be sure to inquire about
underground utilities that may exist.
•
Do not leave the job site unattended without making sure that all fastening
hardware on all components are tightened according to tightening torque
specifications listed on every installation guide. We also recommend roping off
construction area and covering all holes that do not contain a piece of equipment
with plywood or other suitable material.
•
Excavate holes as shown in the footing detail. If a level and clear site cannot
be obtained, adjust the depth of footing to maintain a level footing base. If soil
conditions are loose or unstable, a larger diameter footing may be required. Inquire
with local contractors for appropriate recommendations. Be sure concrete that
might have splashed onto the unit is washed off before it dries. Allow concrete to
harden 72 hours before allowing your structure to be used.
Assemble the entire
structure before pouring concrete unless specifically instructed to do so in
the installation instructions.
•
Insure that Age Appropriate and Hard Surface Warning/Playworld Systems
identification labels are properly affixed to the play equipment. Labels are to be
plainly visible according to current playground equipment guidelines.
