4. Drill a
1
/
8
" pilot hole in the center of each seat rail on
the inside edge of the molded side panel.
(Fig. 2A)
5. Secure each seat rail with one #6 x 1
1
/
4
" deck screw.
(Fig. 2B)
6. Attach one 40-link chain with a
quick link connector
to the front support of molded side panel. Attach one
36-link chain with a
quick link connector
to the back
support of molded side panel. Tighten both
quick link
connectors
with an adjustable wrench.
(Fig. 3)
7. Repeat Step 6 for opposite side.
(Fig. 3)
8. Lift the swing and hook the chains onto the swing
hangers, attaching the
back chains first.
9.
If you are adding the Contoured Leisure Swing to an existing PlayStar Play Action Set, the swing hangers are
already in place. Hang swing from the two outermost hangers inside swing bay.
(Fig. 4A)
10.
If you do not have swing hangers in place, you will need to install them now.
11.
Make two marks in one beam board 48" - 53" apart, centered between posts.
(Fig. 4A)
Caution: The Contoured Leisure Swing must be at least 10" away from the closest
point of all other rides or stationary objects.
12.
Drill a
1
/
4
" dia. hole 2
1
/
2
" deep in the center
of each marked location.
(Fig. 4A)
13.
Screw swing hangers into beam by hand
(a long screwdriver will help). Tighten
swing hanger until loop is tight against
adjoining beam and swing hanger
is parallel with beam.
(Fig. 4B)
14.
Drill another
1
/
4
" dia. hole 2
1
/
2
" deep in
adjoining beam through swing hanger
loop and secure each swing hanger with
one
3
/
8
" x 3" lag screw with washer.
(Fig. 4B)
Fig. 4A
Fig. 4B
48" - 53"
Fig. 2A
Fig. 2B
Drill (12 Places)
Detail
Fig. 3
