7
If you have a
Z|,
" drill bit/counter-sink tool, set
the drill bit depth to the thickness of the board.
(Fig. 1)
Drill locations as marked.
In the assembly instructions, you will be asked to attach the
counter-sunk and predrilled boards with #8 x
2Z|x
" deck screws.
To make this process easier, use the
predrilled boards as templates for drilling
pilot holes into the second boards.
(Fig. 2)
Note: A second drill will make this
process easier by eliminating
multiple changes between drill bit
and counter-sink bit.
TEMPLATE and DRILLING INSTRUCTIONS
ADJUST
Your building kit includes a
Drill
Template to help you create some of
the pilot holes needed to build your
playset.
Position the template and mark only
the holes that need to be drilled
according to the patterns shown
below. Remove the template.
Warning: Do not drill holes through
the template as you may damage
the template.
(Fig. 1)
PLEASE NOTE: Letters represent pattern not position
Note: When the PlayStar logo is showing, the three tabs on the bottom will
position the template square with any two edges. When the arrow is showing,
the two tabs on the bottom will position the template square with one edge
only, which will allow you to slide the template anywhere along the board.
Actual Size Template
TEMPLATE FOR DRILL HOLES
The rigid version of the template like the one
shown here can be found inside your kit.
ADJUST
(Fig. 2)
Warning: Do not counter-sink deeper
than the depth of the screw head.
2" x 4"
C
C
2" x 4"
B
B
1" x 4" or
2" x 4"
A
A
