5.
CRANE
•
Snap crane onto tower.
1.
TOWER
•
Align tabs and posts on tower
with slots and holes in seat.
Snap tower into place.
•
Tighten 4 screws through
underside of seat to secure
tower to seat.
•
Insert drainpipe through slot
and into hole under tower
roof. Be sure bottom end of
drainpipe is inserted into
round flange on seat.
CAUTION:
TO
AVOID BATTERY LEAKAGE
1)
Be sure to insert the batteries correctly
and always follow the toy and battery
manufacturers’ instructions;
2)
Do not mix old and new batteries or alkaline, standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries;
3)
Always remove weak or dead batteries from the product.
Use a Phillips screwdriver to loosen screw in
battery compartment door (screw remains
attached to door). Remove door. Insert 2 fresh
"AA" alkaline batteries as indicated. Replace
door and tighten screw.
BATTERY INSTALLATION
ASSEMBLY
3.
HOUSE
•
Slide elevator connector onto
side rail on house.
Be sure to
do this before installing
house
.
•
Align lip on house with
inside square on seat, and
align side rail on house with
side rail on tower. Snap
house into place.
Tower
Drainpipe
Seat
2.
LIFT
•
Align lip and squares on
lift with slots and squares
on underside of seat, and
snap lift into place.
4.
WORKSHOP
•
Align lip on workshop with
square on seat, and snap
workshop onto seat.
•
Fit workshop door onto
workshop (bumps into holes).
7.
HOUSE DOOR, ELEVATOR, WINDOW
8.
LIFT BUCKET & TRAP DOOR
Peel and apply labels as shown.
Workshop
Workshop
Door
Crane
Large
Window
Scaffolding
Board
•
Fit large window into area
above workshop door.
•
Fit posts on scaffolding board into holes on the side of the large
window. (Fit board into any of the 3 sets of holes.)
•
Insert bottom bump on house door into bottom hole in house
doorway, then snap top bump into top recess on house doorway.
•
Slide tabs on elevator
connector into grooves on
elevator to attach elevator.
•
Fit elevator door onto
elevator (bumps into
holes).
•
Fit small window into area
above top of door.
•
Fit roof onto bottom of
crane tower.
6.
WORKSHOP DOOR, WINDOW, SCAFFOLDING BOARD
LABEL PLACEMENT
Elevator
Door
Elevator
Small
Window
Roof
Trap Door
Door
House
Lift
Elevator
Connector
Lift
Bucket
•
Fit lift bucket onto lift
bracket (bumps into holes).
•
Fit trap door onto seat
(bumps into holes).
Round
flange
Slot
