For Customer Service Call
800.333.8519 (U.S.A.) or
541.955.9199 (International)
Manufactured by Krauss Craft, Inc.
www.playcraftsystems.com
TRI-PAD TRAVERSE RV
INSTALLATION INSTRUCTIONS
Rev C
3/30/2013
RV-1419
Page 4 of 5
Step 5
For Beam to Pin Connection
Attach Disc Traverse Beam as shown in Figure 1.2.
(See Note A)
Step 6
Place Chains into footing holes and attach Tri-Pad
Traverse Stations to Beam as shown in Figure 1.3.
(See Notes A & B)
Step 7
Fully tighten all fasteners according to the
"TIGHTENING TORQUE FOR HARDWARE"
section of the Installation Manual.
Step 8
Plumb and level entire component. Pour concrete
into footing holes. Allow at least 72 hours to cure
before using this equipment. (See Note B)
NOTE: Adjust chain for maximum lateral movement
as shown in Elevation View.
Step 9
Place required protective surfacing under and
around Tri-Pad Traverse. (See Note C)
Step 4
For Beam to Post Connection
Refer to Footing Detail and remove required
post plugs. Attach Disc Traverse Beam as
shown in Figure 1.1. (See Note A)
Figure 1.1
3/8" x 7/8" O.D.
Thick Washer
3/8" x 1" Button
Head Bolt
DISC TRAVERSE BEAM
Figure 1.3
3/8" x 3/4" Button
Head Bolt
3/8" x 1" O.D.
Washer
1/2" SAE
Washer
3/8" x 1-1/8"
Barrel Nut
TRAVERSE U-JOINT
TRI-PAD TRAVERSE
STATION
DISC TRAVERSE
BEAM
1/2" SAE
Washer
1/2" SAE
Washer
3/8" x 3/4" Button
Head Bolt
Figure 1.2
3/8" x 1-3/8"
Barrel Nut
1/2" SAE Washer
3/8" x 1-3/8"
Shoulder Bolt
1/2" SAE Washer
DISC TRAVERSE BEAM
MOUNT PLUG PIN
3/8" x1/2" Socket
Set Screw
