Note
: “hold open” operation is only applied to the wired
installation with external DC powered.
3.
Erase Mode
Selected by Mode SW (“
ERAS
” position), "Red” light flashes.
Erase Primary Key Code:
Enter 4 or 5 key code
Erase Secondary Key Code:
Enter #2 + 4 or 5 key code
#911
Erase all primary codes
#913
Erase hold open code
#914
Erase all secondary codes
4.
EXIT Input
When enabled, “
EXIT
” input will activate primary control relay at
any time.
5.
Program RF Receiver:
Platinum RF receiver needs to be programmed to pair with the
unit. The pairing procedures are:
a.
Program at least one key code (Ex. “1234”) on the unit per the
steps in section 2.
b.
Set the unit back to “
NORM
” mode.
c.
Open RF receiver cover and locate the programming button.
d.
Place RF receiver within the unit RF control range and turn on
RF receiver power.
e.
Push the programming button in RF receiver.
f.
When the programing LED is on in RF receiver, enter the key
code (Ex. “1234” ) on keypad.
g.
When the programming is done, the programming LED will go
off in receiver.
h.
Enter the key code (Ex. “1234”) again, and check the relay in
receiver is activated.
i.
If the programming is unsuccessful, repeat step e to step h.