Platecam SV-5345.IR Скачать руководство пользователя страница 3

REVERSE (MIRROR) IMAGING: 

 

The  SV-5345.IR Camera  has  built-in circuitry to “mirror”  the image so objects on the  right of vehicle 
appear on the right and objects on the left appear on the left when looking at a standard monitor.  If 
your existing monitor or in-dash monitor has a reverse camera input where the monitor itself performs 
the  mirror  image,  then  your  picture  will  not  be  correct.    This  is  due  to  the  fact  the  image  is  being 
mirrored by the plate cam 

and

 mirrored by your monitor.  Check to see if you can control the settings 

in your monitor to turn off the mirror image feature.  

 

 
WIRING: 

 

1.  Carefully  choose  a  hidden  out-of-sight  location  (possibly  behind  the  plate)  for  drilling  the  cable 

hole.  Some  vehicles  may  have  an  existing  hidden  rubber  grommet  or  plug  available  to  avoid 
having  to  drill  into  the  body.    Be  sure  to  double-check for  any  wiring  or  obstructions  behind  the 
surface where you are going to drill the cable hole.  Use the rubber grommet to make a watertight 
seal for the cable where it passes into the vehicle. 

2.  Choose a convenient place to run the camera cable up the left, right or center of the vehicle.  As 

a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise 
or  interference. 

3.  You can connect the camera power at the rear of the vehicle behind the reverse lights. You may 

also connect power inside the vehicle  under the dash or  in the  trunk. The  RED power  wire  goes 
to Reverse Light +12V, and the BLACK wire to Ground.  

4.  Run the YELLOW RCA video cable to your monitor’s video input or reverse camera input. 
5.  There are two small sets of GREEN and WHITE wires that come out of the main camera harness. 

Connect  the  GREEN  wires  together  to  deactivate  the  distance  grid.  Connect  the  WHITE  wires 
together to activate Mirror Imaging.  

 

NOTE

:  Whenever  you  connect  or  disconnect  the  GREEN  or  WHITE  wires,  you  must  remove 

power from the camera and then power it back up for the changes to take effect. 

 

Connect  to +12V

Reverse  Light

MONITOR

Ground

RED  WIRE

BLACK  WIRE

BLACK  Power  Plug

YELLOW:  RCA Video Plug

Connect to Monitor

YELLOW

GREEN  WIRE

WHITE WIRE

Reverse Image  Option

Distance  Grid  Option

SV-5345.IR

 

Отзывы: