INSTRUCTIONS
MSVT-0714-I-5
TypeR24 (24 Watt) solenoid coils, rated IP65 (weather proof and
suitable for outdoors use) are designed to be used with Plast-O-
Matic solenoid valves. The solenoid consists of the coil, plunger
(AKA core), core tube housing and a few other parts. When
energized, the solenoid creates a magnetic field that causes the
core to move thus opening or closing the valve depending on the
design of the valve. You, the end user, must apply the correct
voltage for your particular valve/solenoid. This voltage (and part
number) is imprinted on the coil.
MPORTANT:
these coils
MUST
be operated with the connector
that was supplied by the factory, or the correct replacement
connector if required. If used with the wrong connector, the valve
will not operate. The coil, voltage and part numbers of the coil
and connector are provided below. All connectors are designed
for 1/2” NPT conduit connection. These connectors meet DIN
43650/ISO 4400 form A.
The reason the correct connector must be used is because the
connector performs a special function. It rectifies the voltage.
Rectified voltage has several advantages:
1. It is much quieter than AC voltage, which tends to hum and
occasionally buzz.
2. The coil can be on/off cycled without increasing the heating
like AC coils will.
3. In case the coil is energized without being mounted on the
valve, no harm is done.
TYPE R24 SOLENOID COIL
INSTALLATION AND MAINTENANCE INSTRUCTIONS
IMPORTANT NOTES BEFORE INSTALLING
COIL PART NUMBER
INPUT VOLTAGE
CONNECTOR PART NUMBER
8826E-240VAC
240 VAC
9402
8825E-24VAC
24 VAC
6353
8824E-120VAC
120 VAC
6353
8827E-24VDC
24 VDC
5443
SPECIFICATIONS
Insulation class
H
Watts (maximum)
24
Duty Cycle
100% (may be energized indefinitely, or rapid on/off cycling is acceptable)
Max. Ambient temp
50° C (122° F)
Voltage tolerance
10% above or below rated voltage. **See note below
Current (amps)
See table below.
Enclosure Rating
IP65
**Note at 10% above rated voltage the coil will run a little warmer
COIL PART NUMBER
MAXIMUM CURRENT
8826E-240VAC
0.15
8825E-24VAC
0.85
8824E-120VAC
0.22
INSTALLATION CAUTION:
Electrical wiring shall
be performed by qualified persons in accordance
with all national and local electrical codes. Three wire
(single phase, grounded) is required. A 1/2” NPT
threaded connection and all gaskets supplied must
be used to maintain IP65 weather tight rating.
