Preventive Maintenance | Cooling Pad Replacement
70
Cooling Pad | Installation and Operation Guide Rev B | Doc P/N: 080205039E
5.8 Cooling Pad Replacement
To replace a cooling pad, do the following:
21
22
18
1.
Remove the upper hood (18)
3.
Insert a new cooling pad
and distribution pad
4.
Reattach the upper hood (18)
2.
Tilt the cooling pad (21) forward
and remove both the cooling pad
and distribution pad (22)
NOTE:
If the new cooling pad is too wide, measure the
remaining width needed and add 3 - 5 cm for a
tight fit. Cut the cooling pad to width
NOTE:
Verify that the new pads are installed
according to the orientation arrows
printed on the side of the pads, and
that the black coating is facing out
UP
INSIDE
WWW
