Plantronics Habitat PWF105-C, Руководство пользователя, Страница: 7 / 33

Habitat.Plantronics.com
Plantronics.com/habitat ‐ support
IV. RISER INSTALLATION INSTRUCTIONS (if applicable)
If this was not ordered proceed to following pages
(Some Plantronics features were purchased with a riser to elevate the feature, higher off the ground)

Locate the risers final destination.
o
Note: Make sure there is enough room around this location to slide the riser cover on to the
frame. You will also need enough room around the riser to lift the feature onto the riser, be
sure there is enough head height to place the feature on the riser.

( Recommended ) There are four tabs on the bottom of the frame ‐ these are for securing the riser frame
to the floor if you choose to do so. The necessary hardware for this step varies according to floor type.
Mounting to the floor is highly recommended, but the method is determined by OTHERS, based on
floor material.

On the top of the riser there are (3) ¼ ‐ 20 studs. These correspond to the holes in the bottom of the
reservoir. Take the covers off the top of the reservoir to locate these holes on the bottom of the
reservoir.

There are (2) holes on one side and (1) on the other. This will determine the direction your feature will
face ‐ place your riser frame according to the direction you prefer your feature to face.

Lift your feature into place. The weight of the features vary from between 230 lbs for the 6ft features to
575 lbs for the 10ft features.
o
When lifting the feature you will need at least (5) people, (4) to lift and (1) to guide the feature
onto the studs located on top of the riser frame.

Once the feature is on the riser frame using a 7/16 driver or wrench, secure the feature to the riser with
the ¼ ‐ 20 flat washer, lock washer, and nut ‐ in that order.