Planmeca PlanMill 60 S, Руководство пользователя

Страница: 79 / 114

16.7 Replacing tools in magazine
About this task
NOTE
Only instructed personnel are permitted to replace tools.
NOTE
In order to replace a tool, the user must be familiar with the fundamental
operation of the milling unit and the control software.
The run time of the tools is logged during machining. The preset maximum
service life of the tools is a recommendation and may vary depending on the
material used. The service life can be adjusted in the Edit tool screen.
If the runtime of a tool has expired, it must be replaced. The tool must also
be replaced if it breaks.
Steps
1. Press Tools to open the
Tools menu item.
2. In the
Tool magazine field, select the tool number of the tool to be
replaced.
If the old tool is in the machining spindle, change the tool to any other
tool in tool changer (see section "Changing tools in spindle" on page 72).
3. Press Edit to open the
Edit tool screen.
4. Press Reset next to
Service life (remaining).
5. Click Save.
6. When the cover status display lights up, open the protective door.
7. Remove the old tool from the corresponding tool station.
8. Insert the new tool.
9. Close the protective door.
16.8 Milling
16.8.1 Before milling
Every time before starting to mill:
•
Check the milling unit for visible defects and ensure integrity
• Make sure that all covers and safety equipment are installed and
functioning perfectly
• Make sure that all plug-in connections are securely seated
• Check that the workpiece is secure so that it cannot become loose
during processing
• Check the ambient temperature; this should correspond with the
information provided in the technical data
16 Operating milling unit
User's manual Planmeca PlanMill 60 S 73