Copyright Planika Sp. z o.o.
www.planikafires.com
7
Information and warning alerts
Lp.
Control Panel
Indicators
SOUND
SIGNALS
event
procedure
co
n
st
a
n
t
in
te
rm
it
te
n
t
1
If the fire is not visible - NO
POWER.
Make sure the device is properly connected to the power
supply.
If you see a fire - the device is
in operation.
Do not leave the device unattended by an adult.
2
The device is ready for
operation.
You can run the device in accordance with section B.3
3
No fuel in the tank
Fill the fuel in accordance with B.2 paragraph
4
Initial start-up of the device
Wait for the appearance of fire, the light goes off.
5
Works protected against too
rapid restart of the hot device
or the allowable temperature
has been exceeded
Allow the device to cool down. After cooling the device,
the red indicator will turn off and the green indicator will
start to flash.
6
The device automatically
turns off due to lack of fuel in
the tank.
Allow the device to cool down. After cooling the device,
the red indicator will turn off
7
×
The fuel tank is full.
It is not allowed to pour any more fuel! Close the Fanola
filler bolt. The blue indicator will turn off, the green one
will start to flash.
8
×
There was a fuel spill or
Immediately stop pouring the fuel. Remove the funnel,
dry a visible moisture. Press the START / STOP button to
turn off the sound.
If the spillage is excessive the source
of power needs to be disconnected.
With the use of the
manual pump, supplied by the manufacturer, pump out
at least 1 litre of fuel from the fuel filler. Wait at least 1
hour to evaporate the remaining moisture and then close
the fuel filler bolt. Hold the ECO button for about 5
seconds. If the alarm message reappears, wait a little bit
longer until the rest of the moisture evaporates. If the
message reappears, contact your service provider.
the acceptable device
operation temperature has
been exceeded.
If the alarm message appears during the start of the
device, press the START / STOP button to turn off the
sound and hold the ECO button for about 5 seconds.
If the message reappears, contact your service provider.
9
×
Operation error
Press the START / STOP button to turn off the sound and
hold the ECO button for about 5 seconds.
If the message reappears, contact your service provider.
10
×
The device temperature
below 10°C or critical
operation error
Press the START / STOP button to turn off the sound.
Provide higher ambient temperature. Wait until the
device obtains the indoor temperature. Hold down the
ECO button for about 5 seconds.
If the message reappears, contact your service provider.
11
READY
FUEL
HOT
×
Filler bolt protection error.
Shut the filler bolt. Press the START / STOP button to turn
off the sound and hold the ECO button for about 5
seconds. If the message reappears, contact your service
provider.
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
READY
FUEL
HOT
