5
3.
INSTALLATION
3.1.
Box contents
•
1x complete gas fireplace
•
1x Touch panel (installed)
•
1x Remote control (if delivered)
•
4x AA Batteries
•
2x AAA Batteries (if remote delivered)
•
8x bags of decorative stones
•
1x 4 metre rubber gas linkage
–
installed (only LPG version)
•
1x pressure regulator (37mbar)
–
installed (only LPG version)
•
1x installation and user’s manual
3.2.
Unboxing and installation
•
The contents of the boxes need to be carefully unwrapped from the foam foil.
•
Remove the bags with decorative stones from the burner reservoir and place them away from it.
•
Remove the Styrofoam placed on the unit.
•
Carefully lift the appliance and pull out the glass shield wrapped in cardboard from the inside of the Galio Star
Corten.
•
Check the completeness of the elements with the contents list.
•
Make sure that the device
nor its elements weren’t damaged during the t
ransportation (if they were, notify
the supplier).
•
Place Galio Star Corten on a flat, paved surface outside of the building, preferably on the place of final
installation. Leave sufficient space on the side of the appliance where control panel is located (minimum 1 m).
•
The decorative stones are to be scattered evenly around the reservoir to completely cover the burner of the
fireplace.
•
WARNING!!!
The stones may not cover or be placed inside the device protecting the ignition unit (Picture 2).
Picture 2
•
In the case of Galio Star Corten powered with natural gas, to obtain the optimum image of the flame, cover
the burner with a single layer of decorative stones leaving some spaces uncovered of approximately every
2-3 cm (Picture 2).
Picture 3
•
If all the points were completed according to the instruction the gas bottle can be now
connected.
