Planet VIP-320, Руководство пользователя

Страница: 34 / 51

34
The Default User name is “ admin ” and the password is “ 123 ”
from factory. Press RESET button on rear panel over 5 seconds
will cause the VoIP router reset to this default user name
and password.
Chapter 5
5
System Configurations
System Config
Bridge Mode Setting
This page allows you to disable/enable this device become bridge device or not. When it becomes a
bridge device, bridge interface use LAN's IP address, LAN's subnet mask.
When working on Bride Mode, the VoIP router will use only the LAN setting IP, The VoIP router will use
the same LAN IP setting as WAN IP. That mean, When Bride mode enable, the WAN connection setting
will be ignored.
Date & Time
This page allows you to adjust the date & time settings in this router. The time settings are in 24-hour
format. The router also uses the date and time to time stamp to log events.
Note: When you reset the router, you MUST adjust the date and time again.
Password
This page allows you to change the administration password used to manage this router for security
reasons. o set this password, enter your current password in the Old Password field and then enter a
New password in the New Password and Confirm New Password fields.
Í
Note
Basic Setup
This router comes with the built-in firewall based on the advanced technology of Stateful Packet
Inspection to protect your network from being attacked by hackers. You can set up network access
rules to decide if the network traffic is allowed to pass through (LAN-to-WAN and WAN-to-LAN) the
firewall built inside the router.
In the following sections, you are able to configure firewall settings in this router. Some advanced
knowledge or experiences in TCP/IP internet work are required.
Basic Settings: You can configure basic firewall settings in this router.