16
Chapter 3. Installation
This section describes how to install your
VF-101G/102G/106G-KIT Video over Fiber and make
connections to the converter. Please read the following sections
and perform the procedures in the order being presented. The
hardware installation of PLANET VF-101G/102G/106G-KIT Video
over Fiber Converter does not need software configuration. To
install your VF-101G/102G/106G-KIT on a desktop or shelf,
check the following sections.
3.1 Limitation
The converter does not require any software configuration.
Users can immediately use any feature of this product simply
by plugging in the cable and powering it on. There is some key
limitation on the video over fiber converter. Please check the
following items:
z
The device is used for
Point-to-Point
connection only (trans-
mitter to receiver) and allows video and data to work on the
same optical fiber patch cord.
z
The BNC connector supports 75 ohm cable. The maximum
distance will change by the quality of coaxial cables.
3.2 Preparation before Installing
In order to ensure your normal use, please make sure that
you are using the right optical path, right signal, good power
grounding, and so on. We guarantee all of our products
are subject to strict test and aging, and we simulate field
environment operation tests. Please contact us if there is any
problem.
(1) Please carefully read the user manual of the product before
installing.