24
2. Make sure both sides of the SFP transceiver are with the same
media type; for example, 1000BASE-SX to 1000BASE-SX,
1000BASE-LX to 1000BASE-LX.
3. Check whether the fiber-optic cable type matches the SFP trans
-
ceiver model.
To connect to 1000BASE-SX SFP transceiver, use the multi-mode
fiber cable with one side being the male duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, use the single-mode
fiber cable with one side being the male duplex LC connector type.
Connecting the fiber cable
1. Attach the duplex LC connector on the network cable to the SFP
transceiver.
2. Connect the other end of the cable to a device, switches with SFP
installed, to fiber NIC on a workstation or a Media Converter.
3. Check the LNK/ACT LED of the SFP slot on the front of the Industrial
Gigabit Media Converter. Make sure that the SFP transceiver is oper-
ating correctly.
100BASE-FX:
Before connecting the other switches, workstation or Media Converter,
please do the following:
1. On IGT-1205AT, set the DIP Switch of SFP Port 1 or Port 2 to the
“ON”
position with fiber speed “100FX”.
ON
OFF
Port 1 (DIP 1)
100FX
1000X
Port 2 (DIP 2)
100FX
1000X
2. Make sure both sides of the SFP transceiver are with the same
media type or WDM pair; for example, 100BASE-FX to 100BASE-FX,
100BASE-BX20-U to 100BASE-BX20-D.
3. Check the fiber-optic cable type match the SFP transceiver model.
To connect to MFB-FX SFP transceiver, use the multi-mode fiber
cable with one side being the male duplex LC connector type.
To connect to MFB-F20/F40/F60/FA20/FB20 SFP transceiver, use
the single-mode fiber cable with one side being the male duplex
LC connector type.
