10
Line out
(audio out)
Connect a loud speaker to the network camera. This function is for voice
alerting and two-way audio.
DC-in Jack
The input power is 12VDC.
Note:
ONLY use package power adapter supplied with the internet.
Otherwise, the product may be damaged.
RJ-45
Connects to 10Base-T Ethernet or 100Base-TX Fast Ethernet cabling. This
Ethernet port built N-Way protocol can detect or negotiate the transmission
speed of the network automatically. Please use Category 5 cable to connect
the Network Camera to a 100Mbps Fast Ethernet network switch or hub.
In the LAN socket, there are two LED embedded:
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
Power LED (orange color)
This LED is used to indicate whether DC power is on or not. In addition, this
LED will be flashing while the wireless accessing of the Camera.
Reset Button
This button is used to restore the all factory default settings. Sometimes
restarting the device will make the system back to a normal state. However,
if the system still got problems after restart, user can restore the factory
default settings and install it again.
Restore the device:
a.) Press the button down continuously.
b.) Hold the button at least 5 seconds and release it. Then the
device has been restored to default settings and reboot again.
Note:
Restoring the factory default setting will lose the all previous settings
included IP address forever. User needs to run the PLANET IPWizard II
program to search the device and configure it to let the device work properly
again.
