User’s Manual of ICA-2500
9
In the LAN socket, there are two LEDs embedded:
Power LED (orange color)
This LED is used to indicate whether DC power is on or not.
LAN LED (green color)
This LED will be flashing while network accessing via Ethernet.
6
Factory
Default
Reset
Sometimes restarting the device will make the system back to a normal state.
However, if the system still got problems after restart, user can restore the
factory default settings and install it again.
Restore the device:
1.
Make sure the Camera is ready first. Insert the paper clip or other
suitable tool to press and hold the button down continuously.
2.
Hold it least 5 seconds and release the tool. Then the device has
been restored to default settings and reboot again.
Note:
Restoring the factory default setting will lose the all previous settings
included IP address forever. User needs to run the IPWizard II program to
search the device and configure it to let the device work properly again.
7 DI/DO
Connector
The Internet Camera provides a terminal block with 6 pins of connectors for DI,
DO, and RS485. Please refer to the Appendix A in this manual for more
information.
Cable for I/O connectors:
Name
Number
Function
12VDC
1
DC 12V (50mA maximum)
DI
2
Digital signal input
GND
3
GND
DO
4
Digital signal output
485+
5
RS485 data +
485-
6
RS485 data -
8 Video Out
The Internet Camera also provides composite video output. The video output
function is only for easy installation to check view angle and focus. The output is
not a Mega-pixel resolution. Furthermore, the video output is off by default. To
turn on video, please refer to Setting\Camera\Picture chapter.
9 DC Iris
The Internet Camera supports DC-Iris control.
