– 3 –
– 4 –
4. Searching Door Phone
There are two methods as shown below to search the HDP-1160PT.
Method 1:
Open the Planet Door Phone Finder Utility. Press the Refresh
button to search the HDP-1160PT and find the IP address.
Method 2:
Press and hold the DSS key for 10 seconds. When the
speaker beeps rapidly, press the DSS key again quickly. When the beep
stops, the intercom will report the IP address by voice.
5. Logging in Web UI interface
Input IP address (e.g.http://172.16.0.1) into the address bar of PC’s
web browser.
The default user name is
admin
and password is
123
.
Default Setting
Default IP Address
172.16.0.1
Default Web Port
80
Default Login User Name admin
Default Login Password
123
Report IP Address
Hold the DSS key for 10 seconds to report
IP address by voice
Searching Tools
Planet Door Phone Finder
6. Customer Support
Thank you for purchasing PLANET products. You can browse our online
FAQ resource and User’s Manual on PLANET Web site first to check if it
could solve your issue. If you need more support information, please
contact PLANET support team.
PLANET online FAQs:
http://www.planet.com.tw/en/support/faq.php?key=HDP-1160PT
Support team mail address:
[email protected]
HDP-1160PT Utility:
https://www.planet.com.tw/en/support/download.
php?method=keyword&keyword=HDP-1160PT#list
HDP-1160PT User’s Manual:
https://www.planet.com.tw/en/support/download.
php?&method=keyword&keyword=HDP-1160PT&view=3#list
Copyright© PLANET Technology Corp. 2019.
Contents are subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp.
All other trademarks belong to their respective owners.
4, 6
Two groups of short-circuit output
control interface: used to control electric
locks, alarms, etc.
Left (NC): Normally
Close Contact
Center (COM):
Common Contact
Right (NO):
Normally Open
Contact
7, 8
Two groups of gate magnetic detection
Left: grounded
Right: door
magnetic input
9
Recording output interface: Mix the
device and the sound of the far-end call.
One is the recording signal line, and the
other is the ground line.
(Please be sure to ground the line,
otherwise there will be noise.)
Left: grounded
Right: recording
output
10
External active speaker interface:
External active speakers for audio power
amplification. One is the audio signal
line, and the other is the ground line.
(Please be sure to ground the line,
otherwise there will be noise.)
Left: grounded
Right: external
active speaker
Note
The HDP-1160PT requires either IEEE 802.3af/at PoE or
DC power from the power connector.
2.4 Power Connector
The picture shows the two-pin connector comes with system power
source of DC 12V, 1A (maximum for the two-pin connector).
1
2
+12V DC
GND
3. Installation
Wall mounting steps:
Use the given screw tool to remove the cover.
Place the back cover on the wall and mark the four
holes on the wall with a pencil.
Drill the marked four holes, place the back cover
on the wall, and slightly hammer the plastic
anchors through the four holes.
Get the power cord and network cable connected,
and secure it tightly with the screws.
Caution
While drilling or fixing the HDP-1160PT, hold it tight or
else it may drop that may accidentally hurt the installer.