Case 2: (Peer-to-Peer mode) FRT-420SN Port 1 to Port 2 communications
Supposing one FRT-420SN connects to two telephones, just pick up phone 1 and dial
‘
192*168*0*1**5062
’, phone 2 will ring.
Analog telephone sets are connected to the phone (RJ-11) ports of FRT-420SN respectively
Test the scenario:
1. Pick up the telephone set on Phone 1, and you should be able to hear the dial-tone
2. Press the keypad:
192*168*0*1**5062#
shall be able to connect to the Phone 2
3. Then the telephone set in Phone 2 should ring.
4. The Phone 2 also could dial “
192*168*0*1#
” (without
**5062
) to Phone 1 to establish the voice
communication.
y
If the IP address of the remote calling party is known,
L
Hint
you may directly make calls via its IP address and end
with“
#
”.
y
If the router are installed behind a NAT/firewall/IP
sharing device for Peer-to-Peer VoIP application,
please make sure the NAT device support SIP
applications, and suitable settings should be applied
to the NAT device to enable the SIP communications
before making calls
y
[
FRT-420SN
] in PLANET Router series products, to
connect to remote Router, press the keypad in the
following sequence to connect to the remote FRT-420SN
port 2:
[Remote Router IP address]**5062
, for example:
192*168*0*2**5062
-
65
-
