The following table describes the parameters and buttons of this page:
Field
Description
IP Q
Select to enable or disable IP QoS function. You need to enable IP
Q
rs of this page.
oS
oS if you want to configure the paramete
QoS
Y
d
, or
DSCP based
.
Policy
ou can choose
stream based
,
802.1p base
Schedule Mode
You can choose
strict prior
or
WFQ (4:3:2:1)
.
Src IP
T
acket.
he IP address of the source data p
Src Mask
The subnet mask of the source IP address.
Des
f the destination data packet.
t IP
The IP address o
Dest Mask
The subnet mask of the destination IP address.
Src Port
The port of the s
ource data packet.
Dest Port
The port of the destination data packet.
Protocol
The protocol responds to the
,
U
IP QoS rules. You can choose
TCP
DP
, or
ICMP
.
Phy Port
The LAN interface responds to the IP QoS rules.
Set
is
priority
The priority of the IP QoS rules. P0 is the highest priority and P3
the lowest.
IP Precedence
P
dat
You can choose from 0 to 7 define the priority in the ToS of the I
packet.
a
IP T
T
Y
ize
Reliability
,
Maximize Throughput
,
or
Minimize Delay
.
oS
he type of IP ToS for classifying the data package
ou can choose
Normal Service
,
Minimize Cost
,
Maxim
802.1p
You can choose from 0 to 7.
delete
Select a row in the
QoS rule list
and click it
to delete the row.
delete all
Select all the rows in the
QoS rule list
and click it
to delete the rows.
3.6.5 SNMP
Choose
Advance
>
SNMP
, the page shown in the following figure appears. You can
configure the SNMP parameters.
52
