Chapter 3: Configuration
Overview
The PL-420 uses 56-Bit DES encryption to block outside access. The key is set
by using the Configuration Utility on the CD. By default, the protection is enabled,
however, it is recommended to change the default network password. All your
powerline devices must use the same network password in order to be
connected together.
Diagnose Powerline network
Part 1: Diagnose a Local Powerline device
Double click the
PowerPacket Utility
icon on your desktop, and utility screen will
show up as below:
14
Содержание 85M Powerline to Ethernet Bridge with 4-Port Switch PL-420
Страница 1: ...85M Powerline to Ethernet Bridge with 4 Port Switch PL 420 User Manual ...
Страница 8: ...Wire Diagram 8 ...
Страница 13: ...This screen shows that the installation was completed successfully Click on Finish to exit the wizard 13 ...
Страница 19: ... Note The DEK is unique for EACH Powerline device To use this you will need to input the DEK for each unit 19 ...