Planer Integra 750Plus, Инструкция по эксплуатации

Страница: 17 / 45

17
Installing the Integra 750Plus
3. Continue to lift the door until it is just beyond the vertical position, where it will
remain. Do not force or slam the door back on its hinge or allow the door to fall back
to the closed position, as personal injury or damage may occur.
4. Do not try to turn the door handle. An interlock in the door catch mechanism
prevents the handle from being returned to the closed position while the door is
open.
5. From inside the Integra chamber, remove the following items:
a. Operator's Manual
b. Liquid-nitrogen delivery hose
c. Mains supply cable Serial control cable Sample PRT
d. Exhaust-duct adapter
e. Inner chamber release key
f. Spare-fuse pack
g. Spare sealing-washer pack
6. Close the door and latch it by turning the handle clockwise.
7. Two persons, one at each end, are required to lift and position the Integra safely.
Slide the hands between the fibreglass casing and the lower protective foam to get a
grip on the base of the Integra, then lift it onto the bench or other place of use,
making sure that the door is facing upwards (even for front-loading freezers).
The
door handle must not be used to lift the Integra.
8. Regardless of the intended operating configuration (front-loading or top-loading), it
should now be rotated to place its door to the front. This is to allow access to the
service panels for purpose of connecting electrical and liquid-nitrogen supplies. If the
Integra is configured for top-loading operation, a soft pad should first be placed on the
bench to prevent damage to the fibreglass casing.
Two persons, one at each end, are required to rotate the Integra safely. Grip a
rear foot and a top front corner of the Integra, then carefully lift and rotate the Integra
so that its door faces to the front of the bench. Place the rear edge of the freezer down
first, so that the hands at the front can be slid upwards to prevent them from being
trapped.
Do not open the door of a top-loading freezer.
2.3 Installing the freezer
Remember: if the freezer has been configured for top loading, do not open its door until
the freezer is in the correct orientation.
If you wish to have the freezer modified for top or front loading, call the Service Engineer.
Do not attempt this operation yourself.
Connect the freezer
1. Check that the mains voltage rating shown on the back panel of the freezer correct
for local voltage value (115 or 230). If not correct, contact your supplier and do not
continue to install the freezer.