Planar UltraRes, Руководство пользователя

Страница: 95 / 152

Remote Monitoring Network Setup
Planar UltraRes User Manual 95
c Go to step
6
.
6
Scroll to the bottom of the page and click Confirm and apply new network
settings to receive the Confirm Network Change page.
7
Review the settings to make sure they are correct. Click OK, apply changes
now to receive the Applying Network Changes page. This shows the network
settings that will be used.
Note: If you have changed the static IP address or changed from static to DHCP setup, you
may need to point your browser at the new address.
8
You may have to click the Refresh button on your browser to see the new
name in the upper left corner of the page.
Remote Monitoring Date and Time
Use this page to change date and time information as needed.
1
Set the date and time manually in the box under the Manual Date and Time
section. The date format is very exact. Fill in the current date and time using
exactly the format shown on the page. Click
Set date and time .
2
If you want to have the server periodically check the time from a network
source, fill in the NTP server name or address, and poll interval in the Date and
Time Server section. Click Apply new date and time server settings
.
Note: If you don’t have a preferred NTP server, then pool.ntp.org is a good choice for most
installations.
3
Carefully read the instructions in the Local Time Zone section. Fill in the text
box and click
Set time zone .