Planar LookThru Transparent OLED Display User Manual
020-1380-00D
Page | 11
Tour of the Planar LookThru Transparent OLED Product Family
Tour of the Planar
LookThru Transparent
OLED Product Family
4. Display Architecture
The two members of the Planar LookThru product family are described in this section:
LO552
Standard Model
LO552-S
Straight Mount Model
These two Planar LookThru models are
made up of three subcomponents:
Display Glass
Display Chassis
Electronic box
The Standard Model of the Planar
LookThru, pictured on the right, is intended
for use on a tabletop or attached to a
suitable surface, either upright as shown,
inverted (landscape mode) or side-
mounted in portrait mode. Tiled installation
is also possible.
The Display Glass consists of two pieces
of 2 mm thick Corning Gorilla Glass and a
55-inch diagonal TAMOLED (Transparent
Active Matrix Organic Light Emitting Diode) panel. These components are optically
bonded together employing the proprietary Planar ERO-OLED process. Use of Planar
ERO-OLED results in a combination of optimum optical performance and ruggedness.
The glass assembly, featuring a front surface anti-reflective coating, is less than 8 mm
thick. Bezel dimensions on the left, right, and top side of the display glass is 6.9 mm.
The Display Glass should never be used as the main load-bearing element for mounting
or as a primary handle or principal support during transport.
The Display Glass is securely joined to the display where that attachment surface creates
the bottom bezel for the Planar LookThru. That bezel width is 95 mm. The Display
Chassis also incorporates the five primary M6 mounting points. Leveling feet are installed
in three of these mounting points in the Planar LookThru. The feet should be removed for
a fixed mounting installation. No fewer than three of the primary mounting holes are
