Installing Memory
Figure 10
Do not remove the T-Bar or standoffs.
Each SO DIMM bank is wired in parallel and requires two modules. You can fill
one bank or both. But you should never put just one DIMM module in a bank:
the unit will malfunction.
To remove an SO DIMM module
1. Remove back housing as above.
2. Placing your hands on both sides of the T-Bar, gently open both side catches simultaneously
(apply pressure to the plastic part of the catch, not the metal spring).
3. The SO DIMM module will pop up.
4. Remove the SO DIMM module.
To install a SO DIMM module
1. Remove back panel as above.
2. Placing your hands on both sides of the T-Bar, gently insert the SO DIMM module into an
empty socket. Ensure correct orientation using the module notch located next to the contacts. In
Bank 0 the module orientation notch will face toward the processor. In Bank 1 the module ori-
entation notch will face away from the processor.
3. Push the module down gently until the side catches snap into place, coaxing them if
necessary.
Technical Note:
The SO DIMM module will only insert one way into the socket; do not
force it. If you meet with resistance, check the orientation of the module.
8
Planar Clean Screen PC User’s Manual
SO DIMM bank 0
SO DIMM bank 1
CS Manual LAYOUT#1787 3/9/98 5:33 PM Page 8
