Pulse rate out
Indicated by an “o” on the left hand side of the display, this screen allows selection of the
pulses output per liter or per gallon depending on unit of measure (0.01 PPL/PPG to 100
PPL/PPG).
The meter pulse rate is entered in pulses per liter if the selected unit of measure is liters.
The meter pulse rate is entered in pulses per gallon if the selected unit of measure is
gallons, quarts or pints.
To advance to the next programming screen, hold the TOTAL button.
NOTE:
Error checking will not allow the user to advance to the next screen.
pulse rate out screen
Signal sequence of pulse output
Signal sequence of pulse output
This parameter can be changed for the signal inversion of the pulse output.
io = 1
default setting – (no signal inversion) at no flow condition the pulse
output signal is “1” (high) 24V for example
io = 0
the output is inverted by the software, at no flow condition the pulse
output signal is “0” (low) 0V
Cleaning
Before cleaning, switch off the appliance and disconnect it from the mains. Clean with a
damp cloth. Do not use cleaning agents.
Battery disposal:
The batteries contained in our devices must be disposed of properly in
accordance with §12 of the BattV.
in accordance with §12 of the German Battery Ordinance (BattV) and in
accordance with the the EU directive 2006/66/EC.
DOZ03 / DOZ05 / DOZ07 Instruction manual 02/2021
page 26
