22
1 Installation bracket 2 pcs. 4*40
4 Installation bracket 2 pcs. 4*8
2 Flat bar 2 pcs. 4*30
5 Flat bar 2 pcs. 4*8
3 Suspension device 3 pcs. 4*40
6 Hood 2 pcs. 4*8
WARNING!
Failure to install the screws or fixing device in
accordance with these instructions may result in electrical hazards
.
Installation steps
1.
Install the 2 semi-circular valve flaps (a/b) into the air-outlet-opening of the
appliance. Insert the axles of the valve flaps into the relevant openings (1b) by
bending them carefully (1a). Both valve flaps shall open outwards (2).
2.
Now connect the exhaust hose to the air-outlet
opening of the hood. Put the widened end of the
exhaust hose over the air-outlet. Start at the back
of the air-outlet then proceed from inside the
exhaust hose by installing it (use your thumbs)
on the air-outlet.
3.
Place the suspension device on the wall. Select the position relevant to the
dimensions of the entire appliance. Mark the drillings with a pencil before.
