45
Replacing of the illuminant
1.
Switch off the appliance and disconnect it from
the mains
2.
Remove the cover. Clean the cover and wipe it dry.
3.
Remove the illuminant and replace it by a new one of
the same kind and power:
Heat-proof illuminant for ovens (300
0
C),
230V/25W, E 14 thread.
4.
Install the cover.
Removing of the door
1.
Open the door and push the safety
catches upwards.
2.
Close the door slightly.
3.
Lift the door and pull it towards
your direction.
4.
To reassemble proceed in reverse
order.
5.
Check that the groove of the hinge
bracket is positioned properly in its
guide.
6.
After reassembling the door close the safety catches carefully.
7.
If the safety catches are not closed properly you will damage the hinges.
Removing of the glass panel
1.
Unscrew the screws on the lateral snap locks with a crosshead screwdriver (A).
2.
Press out the snap locks with a flathead screwdriver and pull out the top door
frame (A/B).
3.
Remove the glass panel from its locks at the bottom of the door (C).
4.
Clean the glass panel carefully with warm water and a suitable detergent.
5.
To reassemble proceed in reverse order. Adjust the smooth side of the glass
panel to the upper side.
