4. Install Controller
IV. Pixie Installation cont’d
Optional
: Mount the Pixie to a single-gang wall box (not included). The
inner
screw holes
on the Pixie PCB should be used to affix the Pixie to the wall box.
The
outer screw holes
will be used to affix a Decora™ wall plate over the face of
the Pixie (
Part VII. Complete Installation
).
Plug in the 6V wall wart to power the Pixie.
Warning
: The PXE-DCM is a low-voltage device.
Never install the Pixie be
installed in an electrical back box containing high-voltage wiring.
This would
cause a serious electrical danger and violate United States national electrical
codes.
5. Configure Pixie Audio Feedback (optional)
By default, the Pixie will respond to button presses with an electronically-generated
click sound. To deactivate this sound, press and hold any button on the Pixie while
inserting a paperclip into the Pixie programming aperture. The Pixie will beep
quickly three times to indicate that AUDIO has been set to OFF.
Caution
: Be gentle with the paper clip to ensure that you do not damage switch
mechanism.
8
